Rexroth German High Pressure Hydraulic Gear Pump with 280 Bar and 3 Speed Settings and One Year Warranty

PGH5-2X/160RE07VU2 PGH5-2X/125LR11VU2 PGH5-3X/080RE11VU2 PGH3-2X/013RR07VU2 PGH3-2X/016RE07VU2 High pressure gear pump quantitative Rexroth German hydraulic pump

FAQ:

• Fluid Contamination: Contaminated fluid can damage precision surfaces and cause erratic pressure. Check filters and change the fluid if needed.

• Cavitation: As above, cavitation can also cause pressure fluctuations and must be addressed by ensuring proper suction conditions.

Q7: What should I do if the pump is overheating or unusually noisy?

• Overheating: Ensure the fluid viscosity is correct, the system cooler is functioning, and the pump is not overloaded. Check for restrictions in the discharge line.

• Noise/Vibration: This can indicate cavitation (check suction side), air in the fluid (bleed the system), mechanical wear in bearings or gears, or misalignment between the pump and drive motor. Correct the alignment if necessary.

Q8: What are the essential maintenance practices for PGH gear pumps?

• Regular Inspection: Perform visual checks for leaks, unusual noises, and overheating.

• Fluid Maintenance: Use clean, recommended fluid and monitor its condition. Regularly check and replace suction and pressure filters.

• Lubrication: Ensure bearings are properly lubricated according to manufacturer specifications.

• Seal and Connection Check: Inspect shaft seals and pipe connections for leaks and tighten or replace them as needed.

• Alignment Check: Periodically verify the alignment between the pump and the drive motor.

Q9: Can I get assistance with technical issues or order replacement parts?

Yes, most suppliers and manufacturers offer technical support. For genuine replacement parts (e.g., seals, gears, bearings) and specific troubleshooting guidance for your PGH model, it is recommended to contact the supplier or Bosch Rexroth directly.

Q10: What are the typical warranty terms and production lead times?

Warranty terms can vary by supplier but are often around 60 days for new units. Standard production lead times for MOQ quantities are typically around 15 days, but this can vary based on the product and order size. Always confirm these details with your supplier.

280 Bar Hydraulic Gear Pump

3 Speed Settings Gear Pump

One Year Warranty Internal Gear Pump

Rexroth German High Pressure Hydraulic Gear Pump with 280 Bar and 3 Speed Settings and One Year Warranty Images